Konica Minolta bizhub PRESS 1250 - Manual (Page 103)

● Quality
● Monochrome
See also:
Configuration parameters on page 95
Print parameters on page 97
Quality parameters on page 99
Monochrome parameters on page 100
Configuration parameters
Note: The IPDS workflow is available only with the Trans Pack.
Parameter Option Description
Setup Setup Provides the following options:
● Emulation—This option defines the characteristics of
the IPDS printer emulated by the IC-309m print
controller. When the host inquires to determine which
IPDS printer is connected, the IC-309m print controller
reports this value to the host in a device reply. Certain
emulations are used for more than one printer. The
default option is 4322. This is used for the majority of
emulations, including that of the IBM 4400 Thermal
Printer as well as all other IBM Infoprint printers not
listed explicitly in this option. The IPDS Resolution can
be set to 240, 300, 480, or 600 dpi for the 4322
emulation.
Note: For many of the emulations, the resolution is
limited by the printer, and the IPDS Resolution is
ignored.
● IPDS Resolution—This option specifies the press
supported resolution. You can select: Auto, 240, 300,
480, or 600.
● Valid printing area—Select Border, Move, Edge, or,
Fit
● Report to host on—To control the exceptions and
intervention reporting, select from the following options:
○ VPA Exception
○ Undefined character exception
○ Intervention required
IPDS data traces Enables you to Save IPDS traces.
General Defaults Default code page The selected code page is used as the default character
encoding for the job, unless the IPDS stream already
contains a code page.
Configuration parameters 95