Konica Minolta Magicolor 5450 - Manual (Page 177)

Status, Error, and Service Messages 163
Error Messages (Operator Call: )
This message... means... do this...
ADJUST TRAY1 Tray 1 was specified
with the printer driver
for printing, but Tray 1
is not installed. Install Tray 1.
COVER OPEN
DUPLEX COVER The duplex cover is
open. Close the duplex cover.
COVER OPEN
FRONT COVER The printer’s front
cover is open. Close the front cover.
COVER OPEN
SIDE COVER The printer’s right
side cover is open. Close the right side
cover.
COVER OPEN
TRAY X COVER The right side cover
of Tray X (Tray 3 or
4) is open. Close the right side
cover of the tray.
FUSER MISSING
CHECK UNIT The fuser unit is not
installed. Contact Technical Sup-
port with the error infor-
mation.
HOLD JOB ERROR
UNABLE TO
STORE JOB The specified print job
saved on the hard
disk is sent while the
hard disk is not
installed. Print jobs can be saved
only if a hard disk is
installed. If desired,
install a hard disk.
MANUAL EMPTY
“SIZE”
“MEDIA” Tray 1 was specified
with the printer driver
for printing, but Tray 1
is empty. Load the correct media
into Tray 1.
MANUAL FEED
“SIZE”
“MEDIA” The Paper Source in
the printer driver is
set to Tray 1 (Manual
Feed), but there is
already media in the
tray when printing
begins. Press the Up key to
print, or remove and
reload the paper in Tray
1.