Konica Minolta KIP C7800 - Manual (Page 13)

KIP C7800 Touchscreen Software
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv.
10
Manual - Enables the Quality Image Control System which is checked at that time when the
button is selected.
Execute - After selection of one of the buttons, this sets the desired density control.
Manual Fine - Enables the Quality Image Control System which is checked at that time when the
button is selected with and increased accuracy.
Power Settings
The KIP C7800 incorporates timers to save power and place the printer in “cold sleep mode” to suit
individual company production requirements. These timers can be used to automatically turn off the
printer when the “office is closed”, for example overnight.
Energy Star Settings – Energy Star compliant settings require that the printer goes to Warm Sleep after 15
minutes and into Cold Sleep after 90 minutes of inactivity.
There are two sleep mode settings to choose from, only one can be active at a time and these are
locked by default in the Services settings.
1. Warm/Cold Sleep Timers – This timer can be set to put the printer into a warm/cold sleep mode
after a predetermined period of inactivity.
2. Sleep Time – This time is used in conjunction with the computers clock and is used to put the
Printer to sleep at a pre-set time and wake the printer back up at a pre-set time.
Set the timers by pressing on the hour, minutes as needed.
If the printer is required during the “sleep” period, it will “awake”, produce the prints and then “fall
asleep “again”, 15 minutes later.