A&D Wireless Automatic Blood Pressure Monitor UA851TMW - Manual (Page 7)

A&D Medical (Toll-Free): 1-888-726-9966 | Page E-4
You must install 4 type AA (1.5 volt) batteries (included), or use the
optional AC Adapter (see page E-10 for instruction on using the
monitor with the optional AC adapter) and attach the cuff to the
monitor before using it. To install batteries (or replace them if the “Low
Battery” symbol appears on display), proceed as follows:
1. Remove battery compartment cover by gently
pushing down on arrow and sliding cover forward.
2. Put in bottom row of batteries first. Place the
batteries in compartment with positive (+) and
negative (–) terminals matching those indicated
in the compartment. Be sure batteries make
contact with compartment terminals.
3. Replace cover by sliding it into the compartment
and gently pressing into place.
NOTE: Rechargeable batteries will not work with this monitor.
Step 1
Step 2
Step 3
Your UA-851THW Wireless Automatic Blood Pressure Monitor will work
as a stand-alone device. To use with Wellness Connected follow the
below steps. Before plugging the ActiLink ™ USB Transceiver into your
computer:
1. Go to www.wellnessconnected.com/getstarted
2. Choose the service plan that is best for your needs.
3. Purchase that plan.
4. Download the Wellness Connected software that is appropriate for
your computer.
5. Run the software and follow the installation process.
6. Enter in the required fields (your health information and product
serial numbers).
7. Choose your widgets.
8. Set your goals.
9. Start using Wellness Connected!
Getting Started
Installing the Batteries