Konica Minolta bizhub PRO 1600P - Manual (Page 78)

78 Chapter 19 Safety Information (US)
Instructions for safe use
Instructions for safe use
Introduction
This product is designed with safety as an important feature and according to
international safety standards.
Read and follow these safety rules.
Safety rules
■
Perform only the maintenance procedures that are included in the User Manual.
■
Do not remove screws, hardware or covers, unless you are told to in the User
Manual.
■
Do not remove any covers from the machine. Refer to the User Manual for the
correct procedure about opening the top covers.
■
Do not change fuses in the machine. Call your service engineer.
■
Do not modify the machine. A modified machine is not safe to operate. The
product warranty is voided if you modify the machine.
■
Do not change or adjust the safety interlock switches fitted to the machine.
■
Do not use the machine if the machine makes unusual noises. Turn off the
machine. Disconnect the machine from the main power supply. Call your service
engineer.
Installation
■
Only an approved service engineer is authorized to install the machine.
■
Connect the machine only to an approved power supply with a good ground
connection and a circuit breaker. The correct machine voltage is shown on the
label at the power supply input on the rear of the machine. If the machine is
connected to the wrong supply, the warranty is canceled.
■
Make sure there is sufficient work area around the machine.
■
Install the machine on a level floor.
■
Use caution when you move the machine. The machine is heavy.
Trimmer Blade
This machine contains a power driven trimmer blade. When the machine is operated,
you must follow the safety rules in this document and in the User Manual.
The LCD Screen
Clean the touch screen with a clean, dry cloth. Never use abrasive materials or
chemicals to clean the screen. Gentle pressure with a clean, dry cloth is enough to
remove fingerprints. Do not use excessive force.