Changing the power saver timeout, Changing the power saver timeout -15 – Xerox WorkCentre C2424-3833 User Manual
Page 24
System Settings
WorkCentre® C2424 Copier-Printer
1-15
Using CentreWare IS
To turn on/off the automatic printing of the “Startup Page”:
1.
Launch your web browser.
2.
Enter your system’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3.
Select Properties.
4.
Click the General folder on the left sidebar, then click Printer Defaults.
5.
Under User Preferences, select Off or On from the Startup Page drop-down list to
change the setting.
6.
Click Save Changes at the bottom of the page.
Printing the Startup Page
To print the “Startup Page”:
1.
On the control panel, press the System Setup button.
2.
In the menu, select
Information
, then press the Enter button.
3.
Select
Information Pages
, then press the Enter button.
4.
Select
Startup Page
, then press the Enter button to print.
Note
You can also print the Startup Page from the Troubleshooting tab of the Windows printer
driver.
Changing the Power Saver Timeout
To save energy, the system enters a Power Saver, low-energy consumption mode after a pre-
defined period of time since its last activity. In this mode, most electrical systems are shut
down. When a print job is sent to the system, the system enters Warmup Mode. You can also
warm up the system by pressing the Enter button on the control panel.
Note
When the system enters Power Saver mode, you will hear the printhead moving. This is
part of the normal system operation.
If you find that the system is going into Power Saver mode too often and you do not want to
wait while the system warms up, increase the length of time before the system goes into Power
Saver mode.
To change the Power Saver timeout value, use either:
■
The control panel
■
CentreWare IS
Using the Control Panel
1.
On the control panel, press the System Setup button.
2.
In the menu, select
General Setup
, then press the Enter button.