Xerox 4590 EPS-10912 - Manual (Page 28)

2 2 Security Guide
– If not already enabled, click the 'OK' button in the "Information"
pop-up box
– Click on the 'Add Certificate Button'. This will launch the "Add
Certificate Wizard".
Step 1 - Select "Self-Signed Certificate"
Step 2 - Select and enter either the server
• Domain Name
• IP Address
• Other
Step 3 - Enter the requested information:
• Organization (required)
• Organizational Unit (optional)
• E-mail (optional)
• Locality (optional)
• State/Province (optional)
• Country (required)
Step 4 - Enter the length of time that the certificate will be valid
for.
Step 5 - Verify information entered in previous steps.
Step 6 - A message will appear indicating that the self-signed
certificate has been installed.
NOTE: During steps 2-5, the user may go back and correct any
mistakes made in previous steps.
– Click on the 'Enable SSL/TLS' checkbox at the top of the SSL/
TLS window.
– Select a SSL/TLS mode of operation:
• Normal (Encrypted and Unencrypted Access)
• Secure (Encrypted Access Only)
– Select encryption strength:
• Normal (DES-MD5-56-bit)
• Normal (DES-MD5-40-bit)
• Normal (DES-MD5-128-bit)
• Normal (3DES-MD5-128bit)
• High (RC4-MD5-128-bit)
• High (3DES-MD5-128-bit)
Using an Existing Signed Certificate from a Certificate Authority
– If SSL/TLS is not already enabled