Configure a new wan session, Wan s, Onfigure – ADC MM701G User Manual
Page 34: Ession
Configure a New WAN Session
26
MM701G and MM702G User Manual
C
ONFIGURE
A
N
EW
WAN S
ESSION
You can configure up to 32 total PPPoA, PPPoE, 1483-Bridge, and
1483-Router sessions for the modem. See
for the maximum
number of sessions per each protocol type that can be set up.
A default bridging session is set up. From the WAN configuration
page, define the parameters for each session.
1
Select
WAN
on the menu bar to access the
WAN Configuration
page.
2
To add a new session, choose one of the following protocols from
Select a new session type
.
•
RFC 1483 bridged
if the modem forwards packets based on MAC addresses. You can
enable Spanning Tree when you select Bridge sessions. See
•
RFC 1483 routed
if the modem routes packets based on IP addresses.
•
PPPoA routed
if the modem establishes PPP sessions over ATM with the service
provider and routes packets based on IP addresses.
•
PPPoE routed
if modem establishes PPP sessions over Ethernet with the service
provider and routes packets based on IP addresses.
3
Click
Configure
to access the session page for the protocol type you selected.
4
Go to the appropriate section that follows for the protocol that you selected.
WAN
WAN Setup