Installation, 1 replacing the lamp, 2 closing the door – AEG SCN71800S1 User Manual

Page 18: 1 positioning, 2 electrical connection

Advertising
background image

Problem

Possible cause

Solution

dEMo appears on
the Display.

The appliance is in dem-
onstration mode (dEMo).

Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly.

6.1 Replacing the lamp

The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.

6.2 Closing the door

1.

Clean the door gaskets.

2.

If necessary, adjust the door. Refer
to "Installation".

3.

If necessary, replace the defective
door gaskets. Contact the Service
Center.

7. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.

7.1 Positioning

WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.

The appliance shall have the
plug accessible after installation.

Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:

Cli-
mate
class

Ambient temperature

SN

+10°C to + 32°C

N

+16°C to + 32°C

Cli-
mate
class

Ambient temperature

ST

+16°C to + 38°C

T

+16°C to + 43°C

7.2 Electrical Connection

CAUTION!
Any electrical work required to
install this appliance should be
carried out by a qualified electri-
cian or competent person.

WARNING!
This appliance must be earthed.
The manufacturer declines any li-
ability should these safety meas-
ures not be observed.

18 www.aeg.com

Advertising