AEG S73400CTS1 User Manual

Page 20

Advertising
background image

Problem

Possible cause

Solution

The room temperature is too

high.

Decrease the room temperature.

The FROSTMATIC function is

switched on.

Refer to "FROSTMATIC function".

The COOLMATIC function is

switched on.

Refer to "COOLMATIC function".

Water flows on the rear

plate of the refrigerator.

During the automatic defrosting

process, frost defrosts on the

rear plate.

This is correct.

Water flows into the re-

frigerator.

The water outlet is clogged.

Clean the water outlet.

Products prevent that water

flows into the water collector.

Make sure that products do not

touch the rear plate.

Water flows on the

ground.

The melting water outlet does

not flow in the evaporative tray

above the compressor.

Attach the melting water outlet

to the evaporative tray.

There is too much frost

and ice.

Products are not wrapped prop-

erly.

Wrap the products better.

The door is not closed correctly.

Refer to "Closing the door".

The temperature in the refriger-

ator is too low.

Set a higher temperature.

The temperature in the

appliance is too high.

The door is not closed correctly.

Refer to "Closing the door".

The product temperature is too

high.

Let the product temperature de-

crease to room temperature be-

fore storage.

Many products are stored at the

same time.

Store less products at the same

time.

The temperature in the re-

frigeration is too high.

There is no cold air circulation in

the appliance.

Make sure that there is cold air

circulation in the appliance.

The temperature in the

freezer is too high.

Products are too near to each

other.

Store products so that there is

cold air circulation.

The appliance does not

operate.

The appliance is switched off.

Switch on the appliance.

The mains plug is not connected

to the mains socket correctly.

Connect the mains plug to the

mains socket correctly.

The appliance has no power.

There is no voltage in the mains

socket.

Connect a different electrical ap-

pliance to the mains socket. Con-

tact a qualified electrician.

The lamp does not work.

The lamp is in stand-by.

Close and open the door.

20

What to do if…

Advertising
This manual is related to the following products: