1 replacing the lamp, 2 closing the door – AEG S83600CMM0 User Manual

Page 13

Advertising
background image

Problem

Possible cause

Solution

The temperature in
the refrigeration is
too high.

There is no cold air circu-
lation in the appliance.

Make sure that there is
cold air circulation in the
appliance.

The temperature in
the freezer is too
high.

Products are too near to
each other.

Store products so that
there is cold air circulation.

The appliance does
not operate.

The appliance is switched
off.

Switch on the appliance.

The mains plug is not
connected to the mains
socket correctly.

Connect the mains plug to
the mains socket correctly.

The appliance has no
power. There is no volt-
age in the mains socket.

Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.

The lamp does not
work.

The lamp is in stand-by.

Close and open the door.

The lamp is defective.

Refer to "Replacing the
lamp".

If your appliance is still not working
properly after making the above checks,
contact the After Sales Centre.

7.1 Replacing the lamp

1

2

The appliance is equipped with a longlife
LED interior light.

1.

Disconnect the appliance.

2.

Push the movable part to unhook the
lamp cover (1).

3.

Remove the lamp cover (2).

4.

If needed replace the lamp with a
light of similar characteristic and pow-
er. It is suggested to use Osram PAR-
ATHOM SPECIAL T26 0.8 Watts.

5.

Install the lamp cover.

6.

Connect the appliance.

7.

Open the door. Make sure that the
lamp comes on.

7.2 Closing the door

1.

Clean the door gaskets.

2.

If necessary, adjust the door. Refer
to "Installation".

3.

If necessary, replace the defective
door gaskets. Contact the Service
Center.

ENGLISH

13

Advertising
This manual is related to the following products: