AEG X67453MD0 - Manual (Page 19)

INSTALLATION INSTRUCTIONS 19
Connection control group
• Unscrew the screws near the Air outlet and use these for attaching
the Control Group 50.
• Connect up all the connectors to the sockets provided on the Control
Board Unit, making sure they are compatible.
Flue assembly - mounting the hood body
• Position the upper chimney section and fix the upper part to the
frame using the 2 screws 12c (2,9 x 6,5) provided.
• Similarly, position the lower chimney section and fix the lower part
to the frame using the 2 screws 12c (2,9 x 6,5) provided.
Before fixing the hood body to the frame:
• Screw the 2 screws
12f half way into the holes provided in the sides
of the bottom of the frame.
• Remove the grease filters from the hood canopy.
• Remove any activated charcoal filters.
• Lift the hood canopy and engage the screws
12f in the slots (A) as
far as they will go.
• Working from below, fix the hood canopy to the frame ( B), using
the 4 screws 12q and 4 washers 22 provided, then tighten all the
screws securely.
INSTALLATION INSTRUCTIONS
���
��
��
�
�
��
���
���
���
���
Electrical connection and working test:
• Connect the hood to the mains through a two-pole switch
ha-ving a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Maintenance) be-
ing sure that the connector of the feeding cable is correctly
inserted in the socket placed on the side of the fan.
• Connect the control connector Cmd.
• Connect the lights connector Lux.
• Place the connectors in the junction box 24 and close it
using the 2 screws 12e (2,9 x 9,5) provided.
• Fix the junction box to the hood body using the 2 screws
12c (2,9 x 6,5) provided.
• For the recirculation version, fit the activated carbon odour
filter.
• Replace the grease filters.
��
���
���
���
���