AEG DE4003020M - Manual (Page 20)

Folding down the heating element
1.
Remove the shelf support rails.
2. Hold the heating element with the two
hands at the front
3. Pull it forwards against the spring pres-
sure and out along the support on both
sides.
4. The heating element folds down.
The oven ceiling is ready to clean.
Installing the heating element
1.
Install the heating element in opposite
sequence.
Install the heating element correctly on the two sides above the support on the inner wall
of the oven.
2.
Insert shelf support rails.
Oven door and glass panels
To clean the oven door remove it.
CAUTION!
Be careful when you remove the door from the appliance. The door is heavy!
Removing the oven door
1.
Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two
door hinges fully.
3. Close the oven door until the first posi-
tion (angle approximately 45°).
4. Hold of the oven door with one hand on
each side and pull it away from the oven
at an upwards angle.
Put the oven door with the outer side down
on a soft and level surface to prevent
scratches
5.
Now you can remove the inner glass
panels and clean them.
To install the door follow the procedure
in reverse.
A
A
45°
20 Care and cleaning