AEG HG795440XB - Manual (Page 16)

• Be very careful when you replace the pan supports to prevent the hob top from
damage.
After cleaning, dry the appliance with a soft cloth.
Removing the dirt:
1.
– Remove immediately: melting plastic, plastic foil, and food containing sugar.
– Stop the appliance and let it cool down before you clean: limescale rings, water
rings, fat stains, shiny metallic discolorations. Use a special cleaner applicable for
surface of hob.
2. Clean the appliance with a damp cloth and some detergent.
3. At the end rub the appliance dry with a clean cloth.
To make burners work properly, make sure that pan supports are placed in the way that the
arms are centred upon the burner.
In order to avoid damaging the hob top pay attention when replacing the pan support.
WARNING!
Do not use knives, scrapers or similar instruments to clean the surface of the glass or be-
tween the rims of the burners and the frame (if applicable).
WARNING!
Do not slide cookware over the glass because it could scratch the surface. Also, do not let
hard or sharp objects fall onto the glass or hit the edge of the hob.
Cleaning of the spark plug
This feature is obtained through a ceramic ignition candle with a metal electrode. Keep
these components well clean to prevent difficult lighting and check that the burner crown
holes are not obstructed.
Periodic maintenance
Periodically speak your local Service Force Centre to check the conditions of the gas supply
pipe and the pressure adjuster, if fitted.
WHAT TO DO IF…
Problem Possible cause Remedy
There is no spark when lighting
the gas
• There is no electrical supply • Make sure that the unit is
connected and the electrical
supply is switched on.
• Control the fuse. If the fuse
is released more than one
time, refer to a qualified
electrician.
• Burner cap and crown are
placed uneven
• Make sure that the burner
cap and crown are in correct
positions.
16 What to do if…