AEG NC4003020M - Manual (Page 18)

1
2
2. Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
Valid for telescopic runners:
The retaining pins on the tele-
scopic runners must point to the
front.
9.3 Door and glass panels
Remove the door to clean it.
A
A
Removing the door
CAUTION!
Be careful when you remove the
door from the appliance. The
door is heavy.
1. Open the door as far as it goes.
2. Fully lift up the clamping levers (A)
on the two door hinges.
45°
3. Close the door until it is at an angle
of approximately 45°.
4. Hold the door with one hand on
each side and pull it away from the
appliance at an upwards angle.
Put the door with the outer side
down on a soft and level surface
to prevent scratches.
5. At this time you can remove the in-
ner glass panels and clean them.
To install the door do the above steps in
the opposite sequence.
18 www.aeg.com