AEG X66453BV0 - Manual (Page 11)

MAINTENANCE AND CLEANING 11
MAINTENANCE AND CLEANING MAINTENANCE AND CLEANING
Alarm signal reset
• Turn the Lights and the Suction motor off.
• Press button
H and hold for at least 2 seconds, con-firmation
is provided by the fact that the Led goes out.
Before carrying out any maintenance or cleaning isolate
the cooker hood from the mains supply.
Charcoal Filters
In the recirculation mode the charcoal filters absorb smells and
unwanted odours.
This filter cannot be washed or regenerated, and must be repla-
ced when the Led on Button
H starts to flash, or at least every
4 months. The alarm can only be seen when the Suction motor
is turned on.
Enabling/Disabling the alarm signal
• For Recirculation Version Hoods, the Filter saturation alarm
must be enabled on installation or at a later date.
• Turn the Lights and the Suction motor off.
• Press button
H and hold for at least 5 seconds until the Led
gives confirmation as follows:
• Led flashes twice - Activated Charcoal Filter Alarm ENA-
BLED.
• Led flashes once - Activated Charcoal Filter Alarm DISA-
BLED..
To Remove the Charcoal Filters
• Open the panel by pulling from the center.
• Remove the metal grease filters
• Remove the saturated activated charcoal filter as shown
( A).
• Fit the new filters ( B).
• Replace the metal grease filters.
This appliance can be a possible fire hazard if the grease
and charcoal filters are not cleaned and replaced as
recommended.
A
B