AEG Voxtel D200 - Manual (Page 15)

15
UK
Note:
If there are no numbers in the redial list, the display shows “EMPTY ”.
7.9.2 Store a redial number into the phonebook
t
Follow Steps 1 and 2 in section 7.9.1.
t
Press
OK
and / to select “ADD TO PB“.
t
Press
OK
and then enter the name you want to use in the phonebook.
t
Press
OK
and then modify the number, if necessary.
t
Press
OK
to show “MELODY 1“.
t
Press
/ to browse the ringtone list. The respective ringtone will be
played when browsing the ringtone list.
Note
The selected melody will only be played when you receive a call if you
subscribe to Caller Display and the incoming number matches the stored
number.
t
Press
OK
to confirm, and the entry will be stored.
7.9.3 Delete a redial number
t
Follow Steps 1 and 2 in section 7.9.1.
t
Press
OK
and / to select “DELETE“.
t
Press
OK
to confirm, and the entry will be deleted.
7.9.4 Delete all redial list entries
t
Follow Steps 1 and 2 in section 7.9.1.
t
Press
OK
and / to select “DELETE ALL“.
t
Press
OK
to display “CONFIRM?“.
t
Press
OK
to confirm. All entries will be deleted and the display will show
“EMPTY“.
7.10 Find the handset
You can locate the handset by pressing the find key
14
. All the handsets
registered to the base will produce the paging tone and show “PAGING“
on the display for 60 seconds.
You can stop the paging by pressing on any handset or on the
base again.
Note:
If there is an incoming call during paging, the phone will ring with the
incoming call instead of paging.