AEG MCD1763E-M - Manual (Page 33)

33 Installation
Connecting the appliance to the power supply
• The electrical outlet should be readily accessible so that the
unit can be unplugged easily in an emergency. Or it should be
possible to isolate the oven from the supply by incorporating a
switch in the fixed wiring in accordance with the wiring rules.
• The socket should not be positioned behind the cupboard.
• The best position is above the cupboard, see (A).
• Connect the appliance to a single phase 230-240 V/50 Hz
alternating current via a correctly installed earth socket.
• If the appliance is to be operated in a non-European
country, the supply voltage, current type and frequency of the
appliance indicated on the rating plate must correspond with
the specification of your power supply. The rating plate can be
found on the inside face of the control panel.
• The power supply cord may only be replaced by an electrician.
• Before installing, tie a piece of string to the power supply
cord to facilitate connection to point (A) when the appliance
is being installed.
• When inserting the appliance into the high-sided cupboard,
DO NOT crush the power supply cord.
• Do not immerse the power supply cord or plug in water or
any other liquid.
(A)