AEG AIR AND POWER STATION LA 10 User Manual

Page 19

Advertising
background image

2.2.29 Do not use the compressed air generated
for commercial purposes or for food-, pharma-
ceutical-, diving- or medical purposes.

2.2.28 Immediately shut the unit off after a
maximum of 10 minutes of operation or in the
event of overheating by setting the power switch
to ( O ). Allow the unit to cool down for at least
10 minutes until the regular operating temperature
has been reached and the unit is again ready for
use.

2.2.27 Only carry the unit by the handle. Keep
the handle free of oils, greases and moisture.

2.2.26 Do not overload the unit.

2.2.25 Do not expose the unit to temperatures
over

60 C.

2.2.24 Do not use the unit with the 230 V charg-
ing mains adapter connected.

2.2.23 Always follow the pressure specifications
of the item to be inflated and the manufacturer
instructions.

2.2.22 Especially after inflating tyres on vehicles,
motorcycles and trailers check the air pressure
with a suitable external pressure gauge. Even
minor incorrect air pressures can impact the
driving characteristics. Attention! Risk of
personal injury and property damage!

2.2.21 To prevent malfunctions or the product
being inflated bursting, check the air pressure
with a suitable external pressure gauge whilst
inflating. The unit's manometer is not calibrated,
thus the values shown should only be considered
air pressure guidelines. The manometer does not
indicate a binding, accurate air pressure. Please
refer to the technical data (item 6.0) for the meas-
uring tolerances. Attention! Risk of personal
injury and property damage!

2.2.20 If dusty, clean the area around the valve
before inflating. Wear a dust mask to protect your
respiratory system. Attention! Risk of person-
al injury and property damage!

acids, gasses, objects of any type, or yourself.
Attention! Risk of personal injury and
property damage!

2.2.19 Do not aim the compressed air stream at
individuals, animals, dust, dirt, chemicals,

2.2.18 Use the power switch to power the unit off
before switching valve adapters.

2.2.17 Do not use the unit when fatigued or
under the influence of medications, drugs or
alcohol.

2.2.16 Keep children and other individuals away
from the unit during operation.

2.2.15 Incorrect installation of the valve adapter
or incorrectly attaching or inserting the valve
adapters on / in the item to be inflated may result
in an untight connection between the unit and
product. The leaking air will result in a pressure
drop, and subsequently incorrect air pressure
readings.

2.2.14 If you are unsure about the unit´s function
and operation please consult a qualified
professional.

2.2.13 If the 15 A fuse has been tripped the unit
is not operational and the 12 V vehicle outlet is
not powered.

2.2.12 Improper use of the unit may damage
vehicle electronics. This may then cause an
accident or fire. Attention! Risk of property
damage and personal injury!

2.2.11 Verify the ignition and all loads inside the
vehicle are switched off before connecting the unit
to the 12 V vehicle outlet!

2.2.10 In the event of malfunctions or damage
immediately shut the unit off and disconnect from
the 230 V charging mains adapter or the 12 V
vehicle outlet!

2.2.9 When using the unit's 12 V vehicle outlet
be sure this does not impair the safety and
functionality of other systems and units! Please
follow the instructions in the operating instructions
and the connected unit.

2.2.8 Risk of short circuits! When using the
unit's 12 V vehicle outlet, verify the connected
load has the correct polarity. Refer to the instruc-
tions in the operating instructions and the wiring
diagram of the connected unit.

GB

19

°

97180_Luft-Energiestation_LA_10_Manual _01_08_2012_print

Mittwoch, 1. August 2012 12:30:06

Advertising