AEG KM4400 - Manual (Page 24)

24
Getting started
GB
8. Note: If the Speed selector is
already turned on before the
appliance is plugged in, both the
blue Speed selector LED light and
the Work light will flash OFF and ON
to let you know the Speed selector
has been left on. Turn the Speed
selector to OFF and the lights
will stop flashing. Then resume
operating normally.
7. Work light and Power indicator
light: If the appliance is plugged
in and a speed is selected, a blue
LED lights up around the Speed
selector. A work light will also light
up over the working area. If the
Speed selector is moved to “OFF”,
the working light will automatically
shut off after 3 min.
1. Attachment hub: The appliance
comes with a built in multipurpose
Attachment hub. Read and
carefully follow the instructions
that comes with each attachment
for correct and safe use.
2. Adjusting the Attachment shaft:
The appliance is adjusted at the
factory so that the Flat Beater
clears the bottom of the Bowl. If
the Flat Beater hits the bottom
of the Bowl or is too far away
from the sides, you can adjust
it correctly. See 3 for further
instructions.
3. Turn the Speed selector to “OFF”
and unplug the appliance. Tilt
the Motor head back. Use a slotted
point Head screwdriver to adjust
the screw. Turn counter clockwise
to raise the Attachment shaft, turn
clockwise to lower it.
Other functions