AEG HE604000H - Manual (Page 19)

• Make sure that there is an access to the mains plug after installation.
• Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
• The appliance must not be connected with an extension cable, an adapter or a multiple
connection (risk of fire). Check that the ground connection is in conformity with the
standard and regulations force.
• The power cable must be placed in such a way that it does not touch any hot part.
• Connect the appliance to the mains with a device that lets to disconnect the appliance
from the mains at all poles with a contact opening width of minimum 3 mm, eg. auto-
matic line protecting cut-out, earth leakage trips or fuse.
• None of a parts of the connection cable can not get a temperature 90 °C. The blue neu-
tral cable must be connected to the terminal block label with "N". The brown (or black)
phase cable (fitted in the terminal block contact marked with "L") must always be con-
nected to the live phase.
Replacement of the connection cable
To replace the connection cable use only H05V2V2-F T90 or equivalent type. Make sure that
the cable section is applicable to the voltage and the working temperature. The yellow/
green earth wire must be approximately 2 cm longer than the brown (or black) phase wire.
Assembly
40-50 mm
55 mm
30 mm
min. 650 mm
490 mm
min. 100 mm
270 mm
Before you install the appliance into cut out, put the sealing gasket on the edge of cut out.
The sealing gasket is supplied with the appliance. It prevents spills from sipping to the cabi-
net below.
1. Put the sealing gasket around the edge
of cut out.
2. Put the appliance into cut out and se-
cure it with the clamps. The clamps are
supplied with the accessories bag (see
the diagram). The edge of the appli-
ance top cuts the gasket. Remove the
remaining gasket.
A
B
A) seal to remove
B) supplied clamps
Installation 19