Olympus Tough TG-1 iHS - Manual (Page 27)

27 EN
3 Move the camera slowly while keeping it straight, and
stop the camera where the pointer and target mark
overlap.
● The camera releases the shutter automatically.
To combine only two pictures, press the A button
before taking a third frame.
4 Repeat Step 3 to take a third frame.
● After the third frame is taken, the camera
automatically processes the frames and the
combined panorama image is displayed.
To exit the panorama function without saving an
image, press the  button.
If the shutter does not automatically release, try
[Manual] or [PC].
Taking pictures with [Manual]
1
Use FGHI to specify at which edge the next
picture is to be connected.
Direction for combining
the next frame
MANUAL MANUAL
2 Press the shutter button to take the fi rst frame. The
white-boxed part of the fi rst frame is displayed on joint
area 1.
1st frame
MANUAL MANUAL
1 2 1 2
MENU OK
MANUAL MANUAL
Cancel Save
3 Compose the next shot so that joint area 1 overlaps
joint area 2.
4 Press the shutter button to take the next shot.
Press the A button to combine just 2 frames.
5 Repeat steps 3 and 4 to take a third frame.
● After the third frame is taken, the camera
automatically processes the frames and the
combined panorama image is displayed.
To exit the panorama function without saving an
image, press the  button.
Taking pictures with [PC]
1
Use FGHI to select the direction that the frames
are combined.
2 Press the shutter button to take the fi rst frame, and
then point the camera for the second frame. The
shooting procedure is same as that of [Manual].
Panorama shooting is possible for up to 10 frames.
3 Repeat Step 2 until the number of desired frames is
taken, and then press the A button or  button
when fi nished.
Refer to the PC software help guide for details on
how to make panorama images.
Shooting 3D images Shooting 3D images
In this mode, 3D images are shot for viewing on
3D-compatible display devices.
Images shot in 3D mode cannot be displayed in 3D
on this camera’s monitor.
1 Use HI to select [Auto] or [Manual] and then press
the A button to set.
Submenu 1 Description
Auto
The user only composes the
shots so that the target marks and
pointers overlap, and the camera
automatically releases the shutter.
Manual
After shooting the fi rst frame, move
the camera to overlap the subject
with the image in the monitor. Then
manually release the shutter.