Changing the iso sensitivity, Using sequential (continuous) shooting, Zooming in on your subject – Olympus Stylus 1000 User Manual

Page 21: P. 21, Men u o perat io ns

Advertising
background image

EN

21

Men

u

o

perat

io

ns

• When this is set to [3200] or above, [IMAGE QUALITY] is limited to [2048×1536] or less.

You can take a sequence of pictures at one time by holding down the shutter button. The camera

will take pictures continuously until you release the shutter button.

• In high speed sequential shooting, the flash mode is fixed at [

$] and [IMAGE QUALITY] is limited

to [2048 × 1536].

Combines optical zoom and image capture to enable greater magnification (to a maximum of 5×)

• [IMAGE QUALITY] will be limited to below [2048

× 1536].

The digital zoom can be used to take close-up pictures with stronger magnification than the optical

zoom. (Optical zoom × Digital zoom: the maximum approximately 15×)

ISO ......................................................................................

Changing the ISO sensitivity

AUTO

Sensitivity is automatically adjusted according to the conditions of the

subject.

64/100/200/

400/800/1600/

3200/6400

A low value lowers the sensitivity for daylight shooting of clear, sharp

pictures. The higher the value, the better the camera’s light sensitivity and

ability to shoot with a fast shutter speed and in low light conditions. However,

high sensitivity introduces noise into the resulting picture, which may give it

a grainy appearance.

DRIVE

...........................................................................Using sequential (continuous) shooting

o

Shoots 1 frame at a time when the shutter button is pressed.

i

Focus, exposure and WB are locked at the first frame. The sequential shooting

speed varies depending on the setting of image quality.

ESP/n .............................

Changing the area for measuring the brightness of a subject

ESP

Meters the brightness at the center of the monitor and the surrounding area

separately to capture an image with balanced brightness. When taking

pictures against strong backlight, the center of the picture may appear dark.

n

Only the center of the monitor is metered. Recommended for taking a picture

against strong backlight.

FINE ZOOM

............................. Zooming in on your subject without reducing image quality

OFF /ON

DIGITAL ZOOM

............................................................................ Zooming in on your subject

OFF /ON

P

P

[IN

IN]

44

[

]

HQ

HQ 3648

3648

×2736

2736

White area: The optical zoom area

Red area: The digital zoom area

P

P

[IN

IN]

44

[

]

HQ

HQ 3648

3648

×2736

2736

Optical zoom

Digital zoom

Zoom bar

Advertising