Olympus Tough TG-820 iHS - Manual (Page 33)

33 EN
In the ISO setting, although smaller values result in
less sensitivity, sharp images can be taken under fully
lit conditions. Larger values result in higher sensitivity,
and images can be taken at fast shutter speeds even
under low light conditions. However, high sensitivity
introduces noise into the resulting picture, which may
give it a grainy appearance.
Sequential shooting (Drive)
Pictures are taken sequentially while the shutter button
is held down.
1
Select the drive option in the function menu.
P P
0.0 0.0
MENU MENU
12 M
AUTO
WB
AUTO
WB
AUTO
ISO
AUTO
ISO
2 2
Single
2
Use HI to select the setting option, and
press the A button to set.
Option Description
o
One frame is shot each time the
shutter button is pressed.
j *1
The images are taken sequentially
while holding down the shutter for up
to 100 frames.
c
The camera takes sequential shots
at approximately 15 frames/sec.
d
The camera takes sequential shots
at approximately 60 frames/sec.
*1 The shooting speed varies depending on the settings
for [Image Size] (p. 33) or [Compression] (p. 36).
When set to [ c] or [d], [Image Size] is limited to
[3] or lower, and the ISO sensitivity is fi xed to [ISO
Auto].
When set to [j], the fl ash (p. 20) cannot be set to
[Redeye]. When set to other than [o] or [j], the
fl ash is fi xed to [
$Flash Off].
When set to [ c] or [d], the digital zoom (p. 37) is
not available.
With settings other than [o], the focus, exposure
and the white balance are fi xed when the fi rst frame
is shot.
Selecting the image size for still
images (Image Size)
1
Select the image size option in the function
menu.
P P
MENU MENU
5 M 8 M 12 M 16:9S
AUTO
WB
AUTO
WB
AUTO
ISO
AUTO
ISO
0.0 0.0
12M