Olympus C-750 Ultra Zoom - Manual (Page 89)

88
Remote control shooting
5
Ad
va
nce
d
sho
o
tin
g
TIPS
The self-timer/remote control lamp does not blink after pressing
the shutter button on the remote control device.
Æ
The remote control device may be too far from the camera. Move
closer to the camera and press the shutter button on the remote
control device again.
Æ There is signal interference. Change the channel as described in
the remote control device’s instruction manual.
How to operate the zoom using the remote control device.
Æ
Point the remote control device at the remote control receiver on
the camera. For zooming, press the W or T button on the remote
control device. During operation, the self-timer/remote control lamp
blinks.
How to cancel the remote control mode.
Æ
The remote control mode is not canceled automatically after
shooting. Perform step 2 and set the mode to OFF.
• If the remote control receiver is exposed to strong light, the effective
signal distance may be reduced or shooting may not take place.
• To shoot sequential shots using the remote control device, press
and hold the shutter button on the remote control device. If the
camera does not receive the remote control signal properly,
sequential shooting may stop.
• Read the remote control device’s instruction manual for information
on playback by remote control device.
Note