Olympus Stylus 810 - Manual (Page 50)

50
Co
nnec
ting th
e camera t
o
a
co
mput
er
4
Before installing the OLYMPUS Master software, please confirm that your
computer is compatible with the following system requirements.
For newer operating systems, please refer to the Olympus web site as shown on the
back cover of this manual.
Operating environment
Windows
OS Windows 98SE/Me/2000 Professional/XP
CPU Pentium III 500 MHz or later
RAM 128 MB or more (at least 256 MB is recommended)
Hard disk capacity 300 MB or more
Connector USB port
Monitor 1,024 × 768 pixels, 65,536 colors or more
Note
• Data transfer is only guaranteed on computers with a factory installed OS.
• To install the software in Windows 2000 Professional/XP, you must log on as a
user with administrators’ privileges.
• Internet Explorer and QuickTime 6 or later should be installed on your computer.
• Windows XP corresponds to Windows XP Professional/Home Edition.
• Windows 2000 corresponds to Windows 2000 Professional.
• If you are using Windows 98SE, the USB driver is installed automatically.
Macintosh
OS Mac OS X 10.2 or later
CPU Power PC G3 500 MHz or later
RAM 128 MB or more (at least 256 MB is recommended)
Hard disk capacity 300 MB or more
Connector USB port
Monitor 1,024 × 768 pixels, 32,000 colors or more
Note
• Operation is only guaranteed on a Macintosh equipped with a built-in USB port.
• QuickTime 6 or later and Safari 1.0 or later must be installed.
• Be sure to remove the media (drag & drop onto the trash icon) before performing
the following operations. Failure to do so could result in unstable computer
operation and the need to reboot.
• Disconnect the cable connecting the camera to the computer
• Turn off the camera
• Open the camera’s battery compartment/card cover
Install the OLYMPUS Master software