Olympus LS-10S - Manual (Page 18)

18
Ge
tti
ng S
ta
rte
d
1
2 3 button
`/OK button
When [MemorySelect] is
set to [SD Card], [Built-in
Memory selected
] will
appear
LOCK
3
Close the card cover securely.
Note
• Releasing your finger quickly after pushing the
card inward may cause it to eject forcefully out
of the slot.
Ejecting a Card
1
While the recorder is during stop mode,
open the card cover.
• The card is visibly out of the slot and can
be removed safely.
Notes
• It is possible to switch the recording media over
to the built-in flash memory ( ☞ P.41, P.46).
• In some cases cards which have been format-
ted (initialized) by another device, such as a
computer, cannot be recognized. Be sure to
format them with this recorder before using ( ☞
P.51).
• When attempting to perform operations such as
rewriting the contents of an SD Card in cases
where the card has been write protected, [SD
Card Locked
] will appear. The playback opera-
tion can be performed, but the write protection
must first be turned off when overwriting the
contents on the card.
• Cards that are not to SD standards, such as
multimedia cards, may not be used.
2
Push the card inward to unlock it, and
let it eject partially.
When the SD Card is write protected, there will
be a display reading [SD Card Locked]. Before
inserting the card, turn off the write protection
function. Check the Olympus website regard-
ing SD cards which are confirmed operation
with this recorder ( ☞ P.81).
If the write protection
switch is facing the
[LOCK] direction,
recording and other
functions cannot be
carried out
About the SD Card
Notes
• The recorder may not recognize correctly
on some SD cards. In this case, remove
the card then put it again to see if the
recorder recognizes the card.
• The processing performance reduces in
a SD card when you repeat writing and
delete. In this case, format the SD card
( ☞ P.51).
Inserting and Ejecting a Card