Olympus PT-037 - Manual (Page 19)

EN 19
En
3. Install the digital camera.
Check the digital camera.
Check the digital camera before loading it in the Case.
Battery Confirmation
The flash is used very frequently during underwater shooting.
Make sure that you have enough remaining battery power.
Confirmation of the Remaining Number of Pictures to be Taken
Confirm that the image storage has a sufficient remaining number of
pictures to be taken.
Remove the hand strap from the digital camera.
When a strap is attached to the digital camera, the hand strap must be
removed.
Prepare the camera.
Applicable Digital Cameras
This product (PT-037) is designed exclusively for use with the SP-550UZ/
SP-560UZ digital camera.
Turn on the digital camera.
To save battery power, the camera automatically goes into sleep mode
and the monitor turns off if there is no operation when the camera is turned
on. In this mode, no picture can be taken even if the shutter lever is fully
pressed. Operate the zoom lever or other buttons to restore the camera
from sleep mode before taking a picture. If the camera is left for 12
minutes, it automatically turns off. Press POWER button to turn the
camera on.
Note:
In order to avoid losing shutter chances due to battery exhaustion, it is
recommended to replace the batteries with new or fully charged batteries
before each dive.
CAUTION:
• When a digital camera is loaded without removing the strap, the strap may
get caught between the Case lids and may cause water leakage.
• When removing the strap, handle the digital camera with sufficient care.
OLYMPUS IMAGING CORP. shall not be responsible for damage caused
by dropping the camera etc.
PT037_EN.book Page 19 Monday, August 6, 2007 10:48 AM