Belkin F5U122-PC - Manual (Page 12)

Driver Installation (continued)
1 1
4. A window will appear telling you that Windows has
detected new hardware. If this window does not
appear, contact your PC vendor for assistance.
5. The "Found New Hardware Wizard" will appear.
Click "Next".
6. The "Found New Hardware Wizard" will tell you "The
wizard will complete installation for this device: USB
Ethernet Adapter". Select "Search for a suitable driver
for my device (recommended)" and click "Next".
7. In the following window, place a checkmark next to
"Floppy Disk Drives" and uncheck all other selected
locations and click "OK".
8. The next window will indicate "The wizard found a
driver for the following device: USB Ethernet Adapter".
Click "Next".
9. Next a window will pop up that says "Digital Signature
Not Found". Click "Yes".
10. The next window will tell you "Windows has
finished installing the software for this device". Click
"Finish" to complete the installation.
Once your computer has restarted, the Belkin USB 10/100
Ethernet Adapter will be active and working. If you are
connecting to a cable modem or xDSL modem, follow the
directions that came with your modem or from your
Internet provider.
If you are setting up a network, go to the section titled
P73631_F5U122-PC-man.qxd 4/26/01 10:14 AM Page 11