Belkin F5U122-PC - Manual (Page 15)

Specifying TCP/IP Parameters (continued)
1 4
To access and change the networking properties
in Windows ® 2000
1. Select "My Computer" / "Control Panel" / Network
and Dial-up Connections".
2. Select "Local Area Connection X" that corresponds to
the Belkin Ethernet Adapter. If you have more than one
network interface device, Windows labels them in
sequential order starting at 1. The Belkin Ethernet
Adapter should be the latest network device that was
installed and therefore the latest number.
3. Select "Internet Protocol (TCP/IP)" and click
"Properties".
4. Select "Use the following IP address".
Note: If you are connecting to an existing network,
please see your system administrator for this
information. If you are setting up a new
network, we recommend the
following:
Suggested IP Address = 194.168.0.X (where
"X" is greater than 0 and less than
255).
Suggested Subnet Mask = 255.255.255.0
5. Enter a valid IP Address and Subnet Mask and click
"OK".
6. Select "OK" to close the Local Area Connection
window and finish.
P73631_F5U122-PC-man.qxd 4/26/01 10:14 AM Page 14