Olympus SP-510 UZ - Manual (Page 67)

EN
67
Ge
tti
n
g
to know you
r cam
er
a
bet
ter
Movie
• When [IMAGE QUALITY] is set to [SHQ], the maximum sequential shooting time is
approximately 15 seconds for the cards other than TypeH.
• If you use a non-Olympus card or a card used for another application, such as for a
computer, the message [CARD ERROR] is displayed. To use this card with this camera,
use the [FORMAT] function to format the card.
g “MEMORY FORMAT (FORMAT) Formatting the internal memory or card” (P. 39)
This camera uses several lamps to indicate the camera status.
Image quality Image size Recording length
Internal memory Using a 512 MB card
With sound
Without
sound
With sound
Without
sound
SHQ
640 × 480
(30 frames/sec.)
11 sec. 12 sec.
4 min.
42 sec.
4 min.
43 sec.
HQ
640 × 480
(15 frames/sec.)
23 sec. 24 sec.
9 min.
21 sec.
9 min.
27 sec.
SQ1
320 × 240
(30 frames/sec.)
32 sec. 32 sec.
12 min.
42 sec.
12 min.
54 sec.
SQ2
320 × 240
(15 frames/sec.)
1 min.
03 sec.
1 min.
05 sec.
25 min.
03 sec.
25 min.
48 sec.
Using a new card
Lamp indicators
Lamp Status
Self-timer lamp When set to [ Y 12 SEC]
The lamp lights for approximately 10 seconds, blinks for
approximately 2 seconds, and then the picture is taken.
When set to [
Y 2 SEC]
The lamp blinks for approximately 2 seconds, and then the
picture is taken.
Card access lamp Blinking: A picture is being recorded, the camera is reading
a movie, or images are being downloaded (when
connected to a computer).
• Do not do any of the following while the card access lamp is
blinking. Doing so may prevent the image data from being
saved and render the internal memory or card unusable.
• Open the battery compartment cover/card cover
• Remove the batteries.
• Connect or disconnect the AC adapter.
Green lamp of the
monitor Lit: The focus and exposure are locked.
Blinking: The focus and exposure are not locked.
• Release your finger from the shutter button, re-position
the AF target mark on the subject and press the shutter
button halfway again.