Olympus Tough TG-810 - Manual (Page 58)

58 EN
For information on using the menus, see “Setup menu” (p. 6).
Recording the shooting location and time information on the images shot Recording the shooting location and time information on the images shot
[GPS Settings]
[GPS Settings]
(TG-810 only) (TG-810 only)
t (Settings 3) X GPS Settings
GPS (Global Positioning System) is a system that locates current positions (latitude and longitude) by receiving signals
from satellites. This camera ties in the location information with data and map data, and makes it possible to record the
shooting direction and landmark information on the images.
GPS is subject to the laws of the country or region concerned. Be absolutely sure to comply with these laws.
Set the GPS function to [Off] inside airplanes and other places where use of the GPS function is prohibited.
While the GPS function is set to [On], it stays activated even if the camera’s power is off so the battery power will
continue to be consumed.
Submenu 2 Submenu 3 Application
GPS
On When the GPS function is going to be used.
Off When the GPS function is not going to be used.
Status When the location information screen is to be displayed.
Country/Region
On When the country or region is to be displayed.
Off When the country or region is not to be displayed.
State/Province
On When the state or province is to be displayed.
Off When the state or province is not to be displayed.
City
On When the city is to be displayed.
Off When the city is not to be displayed.
Landmark
On When the landmark is to be displayed.
Off When the landmark is not to be displayed.
Only the landmark information registered near the shooting location is displayed.
Under some conditions of use, the GPS information may not be recorded accurately. Refer to “Concerning GPS”
(p. 73).
When GPS has been set to [On], the [Power Save] mode is automatically set to [Off].
The GPS information may not be recorded when the camera time has not been set or when settings have been
changed.