Olympus D-555 Zoom ImageLink - Manual (Page 101)

Troubleshooting
101
9
Appendix
The subject was out of
the working range of the
flash. Shoot within the flash working range. P. 34
The subject was too
small and was backlit. Set the flash to [#]. P. 34
The sequential shooting
mode was used. Higher shutter speeds are used during
sequential shooting, which may result in
pictures that are darker than usual. Set
[DRIVE] to [o]. P. 41
The center of the subject
is too bright. If the center of the subject is too bright, the
image as a whole emerges darker. Adjust the
exposure compensation toward plus (+). P. 37
Bright subjects such as
snow will turn out darker
than their natural colors
in the image. Adjust the exposure compensation toward
plus (+). P. 37
The colors of pictures look unnatural.
Indoor lighting affected
the picture’s colors.
Set the white balance according to the
lighting. P. 38
No white in the picture. Include something white in the picture, or
shoot using [
#].
P. 34
The white balance
setting is wrong. Adjust the white balance according to the
light source. P. 38
Part of the picture is dark.
The lens was partly
blocked by your finger or
the strap.
Hold the camera correctly, keeping your
fingers and the strap away from the lens. P. 19
Pictures you have taken do not appear on the monitor.
The power is off.
Slide the POWER switch to q to turn the
camera on in playback mode.
P. 9
The camera is in the
shooting mode. Press the QUICK VIEW button or slide the
POWER switch to
q to switch to the
playback mode.
P. 9
There are no pictures in
the card. [NO PICTURE] is displayed on the monitor.
Record pictures. –
There is a problem with
the card. See “Error codes”. P. 96
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
Cancel the protection of the pictures. P. 54
Possible cause Corrective action
Ref.
page
d4255_e_00_0_bookfile.book Page 101 Monday, June 6, 2005 11:08 AM