Olympus D-555 Zoom ImageLink User Manual
Page 102
Troubleshooting
102
9
Appendix
(When the camera is connected to a computer or printer
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
Use [s] to adjust monitor brightness.
The monitor is exposed
to direct sunlight.
Block the sunlight with your hand.
–
Possible cause
Corrective action
Ref.
page
The printer fails to connect.
[PC] was selected on the
monitor after connecting
the camera to the printer
with the USB cable.
Remove the USB cable, and start again from
Step 1 of “Printing pictures”.
The printer does not
support PictBridge.
Refer to the printer’s instruction manual or
contact the manufacturer.
–
The camera is not recognized by the computer.
The computer failed to
recognize the camera.
Disconnect the USB cable from the camera,
and connect it again.
The USB driver has not
been installed.
Install OLYMPUS Master.
Possible cause
Corrective action
Ref.
page
d4255_e_00_0_bookfile.book Page 102 Monday, June 6, 2005 11:08 AM