Olympus D-595 Zoom - Manual (Page 128)

Troubleshooting
128
9
Appendix
The subject was out of
the working range of the
flash. Shoot within the flash working range. P. 42
The subject was too
small and was backlit. Set the flash to [ #], or use the spot metering
mode.
P. 42,
46
The sequential shooting
mode was used. Higher shutter speeds are used during
sequential shooting, which may result in
pictures that are darker than usual. Set [j]
to [OFF]. P. 52
The center of the subject
is too bright. If the center of the subject is too bright, the
image as a whole emerges darker. Adjust the
exposure compensation toward plus (+). P. 44
The aperture value is too
high in M mode. Decrease the aperture value or set the
camera to P mode. P. 46
The shutter speed is too
fast in M mode. Reduce the shutter speed or set the camera
to P mode. P. 46
Bright subjects such as
snow will turn out darker
than their natural colors
in the image. Adjust the exposure compensation toward
plus (+). P. 44
The colors of pictures look unnatural.
Indoor lighting affected
the picture’s colors.
Set the white balance according to the
lighting. P. 48
No white in the picture. Include something white in the picture, or
shoot using [
#].
P. 42
The white balance
setting is wrong. Adjust the white balance according to the
light source. P. 48
Part of the picture is dark.
The lens was partly
blocked by your finger or
the strap.
Hold the camera correctly, keeping your
fingers and the strap away from the lens. P. 23
Pictures you have taken do not appear on the monitor.
The power is off.
Press $ to turn the camera on in playback
mode.
P. 10
The camera is in the
shooting mode. Press $ to switch to playback mode. P. 10,
11
Possible cause Corrective action
Ref.
page