Olympus D-595 Zoom - Manual (Page 129)

Troubleshooting
129
9
Appendix
(When the camera is connected to a computer or printer
There are no pictures in
internal memory or card. [NO PICTURE] is displayed on the monitor.
Record pictures. –
There is a problem with
the card. See “Error codes”. P. 122
The camera is
connected to a TV. The monitor does not function when the AV
cable is connected to the camera. P. 72
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
Cancel the protection of the pictures. P. 75
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
Set the video output signal according to the
region where used. P. 73
The TV video signal
setting is incorrect. Set the TV to the video input mode. P. 72
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
Use [s] to adjust monitor brightness. P. 89
The monitor is exposed
to direct sunlight. Block the sunlight with your hand. –
Possible cause Corrective action
Ref.
page
The printer fails to connect.
[PC] was selected on the
monitor after connecting
the camera to the printer
with the USB cable.
Remove the USB cable, and start again from
Step 1 of “Printing pictures”. P. 93
The printer does not
support PictBridge. Refer to the printer’s instruction manual or
contact the manufacturer. –
The camera is not recognized by the computer.
The computer failed to
recognize the camera.
Disconnect the USB cable from the camera,
and connect it again. P. 93
The USB driver has not
been installed. Install OLYMPUS Master. P. 108
Possible cause Corrective action
Ref.
page