Olympus C-3000 Zoom - Manual (Page 74)

224
TROUBLESHOOTING (Cont.)
Image protect, Single-erase, All-frame erase or Card format cannot
be performed.
1 A write-protect adhesive seal is affixed to the card.
[ Use the card after peeling off the seal. Do not reuse the write
protect seal. (P. 121)
PROBLEMS WITH IMAGES
The picture is out of focus
1 The camera moved when the shutter button was pressed.
[ Hold the camera correctly, and press the shutter button.
(P. 38/39)
2 The viewfinder’s autofocus mark was not positioned on the subject.
[ Position the autofocus frame on the subject, or use the focus
lock. (P. 53/131)
3 The lens is dirty.
[ Clean the lens with a soft dry cloth.
4 The mode was not selected correctly.
[ Shoot with the Macro mode when the subject is within the range
of 8"~31". For further distances, shoot with the Standard mode.
(P. 56/69)
5 The Shutter release button was pressed while atanding in front of the
camera in the Selftimer mode.
[ Press the Shutter release button while looking into the viewfinder,
not while standing in front of the camera. Or, use the remote
control. (P. 76/138)
6 The Manual focus was used with the wrong focal range.
[ Use the right Manual focus for the distance. (P. 71/135)
The picture is too dark.
1 The flash was blocked by a finger.
[ Hold the camera correctly, keeping your fingers away from the
flash. (P. 38)
2 The subject was out of the working range of the flash.
[ Shoot within the flash working range. Or, use an extension flash.
(P. 64/92)
3 The flash mode was set to the Off mode.
[ Check the flash mode before shooting. (P. 64)