Olympus FE-340 - Manual (Page 38)

38
EN
Usi
ng O
LY
M
PU
S
Mast
er
1
Make sure the camera is turned off.
• The monitor is off.
• The lens is retracted.
2
Connect the multi-connector on the camera to the
USB port on the computer using the provided USB
cable.
• Refer to your computer’s instruction manual to locate the position
of the USB port.
• The camera turns on automatically.
• The monitor turns on and the selection screen for the USB
connection is displayed.
3
Select [PC], and press .
4
The camera is recognized by the computer.
• Windows
When you connect the camera to your computer for the first time,
the computer attempts to recognize the camera. Click “OK” to exit the message that is
displayed. The camera is recognized as a “Removable Disk”.
• Macintosh
The iPhoto program is the default application for managing digital images. When you connect
your digital camera for the first time, the iPhoto application starts automatically, so close this
application and start OLYMPUS Master.
Note
• The camera functions are disabled while the camera is connected to a computer.
• Connecting the camera to a computer via a USB hub may cause unstable operation. In this
case, do not use a hub, but connect the camera directly to the computer.
• Images cannot be transferred to your computer with OLYMPUS Master if [PC] is selected in
Step 3, Y is pressed and [MTP] is selected.
Connecting the camera to a computer
Monitor
Multi-connector
Multi-connector
FE-340/X-855/C-560
FE-320/X-835/C-540
Connector
cover
U S B
P C
EASY PRINT
CUSTOM PRINT
EXIT
SET OK
d4362_63_e_0000_7.book Page 38 Tuesday, November 13, 2007 8:43 PM