Olympus SP-500 UZ - Manual (Page 158)

Troubleshooting
158
10
Appendix
Pictures you have taken do not appear on the monitor.
The power is off.
Set the mode dial to a mode other than q,
and press the POWER button.
P. 22
The camera is in the
shooting mode. Press the QUICK VIEW button or set the
mode dial to
q.
P. 10,
74
The viewfinder is turned
on.
Press u to switch to the monitor. P. 12
There are no pictures in
the internal memory or
on the card. [NO PICTURE] is displayed on the monitor.
Record pictures. –
There is a problem with
the card. See “Error messages”. P. 151
The camera is
connected to a TV. The monitor does not function when the AV
cable is connected to the camera. P. 97
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
Cancel the protection of the pictures. P. 99
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
Set the video output signal according to the
region where used. P. 98
The TV video signal
setting is incorrect. Set the TV to the video input mode. –
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
Use [s] to adjust the brightness. P. 110
The monitor is exposed
to direct sunlight. Block the sunlight with your hand. –
Possible cause Corrective action
Ref.
page