Olympus PT-035 - Manual (Page 57)

EN 19
EN
Seal the Case.
Check the operation of the loaded camera.
After sealing the Case, check that the camera functions normally.
1 Push the POWER button on the Case and confirm that the camera
turns ON/OFF.
2 Press the K/h/ s button on the Case and confirm that the
camera mode switches properly.
• Check if the correct mode is being switched from the LCD monitor.
3 Press the shutter lever on the Case and confirm that the camera
shutter releases.
• Also operate other control buttons on the Case and confirm that the
camera functions properly.
Close the rear lid gently (so that the
O-ring does not slip out of the
groove), hook the buckle on the
edge of the rear lid, and tilt the
buckle lock/unlock lever in the
direction of the arrow to seal the
Case hermetically.
CAUTION:
• Seal the Case by turning both buckle lock levers down in arrow direction.
When one of the buckles is left open, the Case will not be sealed and water
leakage will occur.
• Close the rear lid of the Case so that the LCD hood and the lens cap strap
don’t catch. If they catch, water leaks may result.
PT-035_EN.book Page 19 Wednesday, January 10, 2007 1:33 PM