Erasing – Olympus LS-5 User Manual
Page 40
0
About Playback
3
Notes
• Partial erase is not applicable to files recorded
in the WMA or MP3 formats.
• The File Created Date will not change even if
the file is partially erased.
• An erased file cannot be restored. When an
SD Card is inserted in the recorder, be sure to
confirm the recording media as either [
Built-
in Memory] or [SD Card] so that there is no
mistake (☞ P.41, P.46).
• When attempting to perform operations such as
rewriting the contents of an SD Card in cases
where the card has been write protected, [
SD
Card Locked] will appear. The playback opera-
tion can be performed, but the write protection
must first be turned off when overwriting the
contents on the card (☞ P.18).
• The locked files and files set as read-only
cannot be erased (☞ P.41, P.47).
• If an action is not selected within 8 seconds,
the recorder will return to stop status.
• Never perform operations such as the following
while processing, as they may damage the
data. In addition, replace the batteries with two
new ones in order to ensure that the batteries
will not run out while processing.
1 Turning off the power while processing.
2 Removing the batteries while processing.
3 Remove the SD Card during processing
when [
SD Card] is being used as the record-
ing media.
Performing any of these operations may dam-
age the data.
• You cannot delete folders through the re-
corder.
At the position you want to end partial
erase, press the
ERASE button again.
• The display will switch to [
Partial Erasing !]
and start the partial erase. The deletion is
completed when [
Partial erase completed]
is displayed.
• Playback will stop at the end location of the
partial erase.
Press the
ERASE button again.
• [
Partial Erase Start Position] and [Partial
Erase End Position] on the display flash
alternately. When the lights are flashing,
playback continues and you can rewind or
fast-forward as usual and fast-forward to
the end of erase. If the file reaches the end
during the flashing of the lights, that will be
the position where erase ends.
Erasing