Olympus FE-5040 - Manual (Page 43)

43 EN
For information on using the menus, see “Using the Menu” (p. 4).
Adjusting the CCD and the image Adjusting the CCD and the image
processing function [PIXEL MAPPING]
processing function [PIXEL MAPPING]
s (Settings 2) X PIXEL MAPPING
This function has already been adjusted at factory
shipping, and no adjustment is needed right
after purchase. Approximately once a year is
recommended.
For best results, wait at least one minute after taking
or viewing pictures before performing pixel mapping.
If the camera is turned off during pixel mapping, be
sure to perform it again.
To adjust the CCD and the image To adjust the CCD and the image
processing function
processing function
Press the H button when [START] (Submenu 2) is
displayed.
The camera checks and adjusts the CCD and the
image processing function at the same time. ●
Adjusting the brightness of the monitor Adjusting the brightness of the monitor
[[s
s]]
s (Settings 2) X s
Submenu 2 Application
BRIGHT/
NORMAL
Selects the monitor brightness
depending on the surrounding
brightness.