Billion Electric Company 400G - Manual (Page 42)

Billion 400G Router
Chapter 4: Configuration
39
Pure Bridge
Profile Port: Select the profile port ADSL.
Protocol: The ATM protocol will be used in the device.
Description: User-definable name for the connection.
VPI/VCI: Enter the information provided by your ISP.
ATM Class: The Quality of Service for ATM layer.
Encap. mode: Select the encapsulation format, this is provided by your ISP.
Acceptable Frame Type: Specify which kind of traffic goes through this connection, all traffic or only VLAN tagged.
Filter Type: Specify the type of ethernet filtering performed by the named bridge interface.
All Allows all types of ethernet packets through the port.
IP Allows only IP/ARP types of ethernet packets through the port.
PPPoE Allows only PPPoE types of ethernet packets through the port.
Obtain DNS: A Domain Name System (DNS) contains a mapping table for mapping between Domain Names
and IP addresses. On the Internet, every host has a unique and user-friendly name (domain name) such as
www.helloworld.com as well as an IP address. An IP address is a 32-bit number in the form of xxx.xxx.xxx.xxx,
for example 10.0.0.2. You can think of an IP address as a telephone number for devices on the Internet, and the
DNS will allow you to find the telephone number for any particular domain name. As an IP Address is hard to
remember, the DNS converts the friendly name into its equivalent IP Address.
You can obtain a Domain Name System (DNS) IP address automatically if your ISP provides it when you logon.
To use this automatically supplied DNS check the Enable box.
Primary DNS: Enter the primary DNS.
Secondary DNS: Enter the secondary DNS.