Pioneer AVIC-X1 - Manual (Page 17)

15
Ch
ap
te
r
1
H
ow
to
U
se Na
vig
ati
o
n
U
n
it a
n
d
Na
m
es
o
f t
h
e Pa
rts
Opening and closing the LCD
panel
• Do not close the LCD panel with hands by
force. That cause malfunction.
The LCD panel will be opened or closed
automatically with the turning of the ignition
switch on or off. You can turn off the automatic
close/open function.
➲ Setting close/open function ➞ Operation
Manual
• The automatic close/open function will operate
the display as follows.
– When the ignition switch is turned OFF
while the LCD panel is open, the LCD panel
will close after six seconds.
– When the ignition switch is turned ON again
(or turned to ACC), the LCD panel will open
automatically.
– Removing or attaching the front panel will
automatically close or open the LCD panel.
➲ Removing the front panel ➞ Page 17
• When the ignition switch is turned OFF after
the LCD panel has been closed, turning the
ignition switch ON again (or turning it to ACC)
will not open the LCD panel. In this case, press
OPEN/CLOSE button to open the LCD panel.
• When closing the LCD panel, check to make
sure that it has closed completely. If the LCD
panel has stopped halfway, leaving it like this
could result in damage.
• Press OPEN/CLOSE button to open the
LCD panel.
❒
To close the LCD panel, press OPEN/
CLOSE button again.
Adjusting the LCD panel angle
Important:
• If you can hear the LCD panel knocking against
your vehicle’s console or dashboard, press
ANGLE (–) button to move the LCD panel a
little forward.
• When adjusting the LCD panel angle, be sure
to press ANGLE (+/–) button. Forcibly
adjusting the LCD panel by hand may damage
it.
• Press ANGLE (+/–) button to adjust the
LCD panel to an easily viewable angle.
The LCD panel angle continues changing as
long as you press ANGLE (+/–) button and
hold.
❒ The adjusted the LCD panel angle will be
memorised and the LCD panel will
automatically return to this angle the next
time the LCD panel is opened.
Turning the LCD panel
horizontal
When the LCD panel is upright and it hinders the
operation of the air conditioner, the position of
the panel can be turned horizontal temporarily.
• Press FLIP DOWN/CLOCK button to turn
the LCD panel horizontal.
❒
To return to original position, press FLIP
DOWN/CLOCK button again.
❒ The LCD panel returns to the original
position automatically with beep sounds
10 seconds after operation.
MAN-AVIC-X1-EN HW.book Page 15 Friday, January 16, 2004 11:41 AM