Pioneer AVH-X7500BT - Manual (Page 46)

46
EN
G
L
IS
H
System settings
Setting the safe mode
This setting restricts your operation for Bluetooth device while driving.
If this mode is set to on, the following operations are not possible.
• Use of the keyboard function in AppRadio Mode
• Calling using entering phone number mode
• All operations in the Bluetooth connection menu
! CAUTION
For your safety, safe mode must always be set “On” while driving.
1. Press the home button to switch to the home display.
2. Touch the system key to open the system menu.
3. Touch Safe Mode on the system menu to turn Bluetooth safe mode on or off.
Setting the rear view camera (back up camera)
! CAUTION
Pioneer recommends the use of a camera which outputs mirror-reversed
images. Otherwise, the screen image will appear reversed.
This unit features a function that automatically switches to the rear view camera video
(REAR VIEW CAMERA IN) when a rear view camera is installed on your car and the
shift lever is moved to the REVERSE (R) position. (For more details, consult your
dealer.)
You can also switch the rear view image by pressing the touch panel key.
For details refer to “Using the rear view” on page 10.
• After you set up the rear view camera setting, move the shift lever to REVERSE (R)
and confirm that the rear view camera video is shown on the display.
• Change this setting if the display switches to the rear view camera video by error
while you are driving forward.
• To stop watching the rear view camera video and return to the source display, press
and hold MUTE.
• Touch the RearView icon to display the rear view camera image while driving.
Touch the source icon again to turn the rear view camera off. For details, refer to
“Selecting a source” on page 8.
1. Press the home button to switch to the home display.
2. Touch the system key to open the system menu.
3. Touch Camera Polarity on the system menu to select the appropriate setting.
• Battery – When the polarity of the connected lead is positive while the shift lever is
in REVERSE (R) position
• Ground – When the polarity of the connected lead is negative while the shift lever
is in REVERSE (R) position
• Off – When a rear view camera is not connected to this unit
• The rear view key setting also turns off on the home display screen.
Auto EQ (auto-equalizing)
The auto-equalizer automatically measures the car’s interior acoustic characteristics,
and then creates an auto-equalizer curve based on that information.
• To perform this function, dedicated microphone (e.g. CD-MC20) is required.
! WARNING
As a loud tone (noise) may be emitted from the speakers when measuring the car’s
interior acoustic characteristics, never perform auto TA or auto EQ while driving.
! CAUTION
• Thoroughly check the conditions before performing auto EQ as the speakers may
be damaged if these functions are performed when:
– The speakers are incorrectly connected. (For example, when a rear speaker is
connected as a subwoofer output.)
– A speaker is connected to a power amp delivering output higher than the
speaker’s maximum input power capability.
• If the microphone is placed in an unsuitable position the measurement tone may
become loud and measurement may take a long time, resulting in battery drainage.
Be sure to place the microphone in the specified location.
Before operating the auto EQ function
• Carry out auto EQ in as quiet a place as possible, with the car engine and air
conditioning switched off. Also cut power to car phones or portable telephones in the
car, or remove them from the car before carrying out auto EQ. Sounds other than
the measurement tone (surrounding sounds, engine sound, telephones ringing etc.)
may prevent correct measurement of the car interior acoustic characteristics.
13-MAN-AVH7500-GB.fm Page 46 Thursday, February 28, 2013 10:20 AM