01 before you start, What’s in the box, Before using the remote control – Pioneer XW-NAC1 User Manual

Page 5: Replace the battery, Before you start, Before you start 01, Chapter 1

Advertising
background image

Before you start

01

5

En

English

Français

Español

Chapter 1:

Before you start

What’s in the box

Please confirm that the following accessories

are in the box when you open it.

• Remote control
• Lithium battery (CR2025)

(The lithium battery has been factory

installed in the remote control unit.)

• Power cord
• Warranty card
• Operating instructions (This document)

Before using the remote control

The battery supplied with this unit is stored in

the battery casing.

•

Remove the protective seal from the

battery casing.
When you notice a decrease in the operating

range, replace the battery (see below).

Replace the battery

When replacing the battery, use a

commercially available Lithium CR2025

battery.

1

While pushing the release tab, pull out

the battery casing.

2

Remove the battery from the casing.

3

Place a new battery in the casing.

Make sure the  side of the battery is facing up

when you place it in the space provided.

Caution

When using lithium batteries, please observe

the following:

• There is danger of explosion if the battery is

incorrectly replaced. Make sure to replace

only with the same or equivalent type

recommended by the manufacturer.

• Dispose of used battery cells immediately

after replacement. Keep away from

children.

• If swallowed, please contact a doctor

immediately.

• Lithium batteries may present a fire or

chemical burn hazard if misused. Do not

disassemble, heat above 100 °C, or

incinerate.

1

1

3

2

XW-NAC1_SYXJ.book 5 ページ 2010年3月10日 水曜日 午前11時46分

Advertising