Pioneer KRF-9000FD - Manual (Page 29)

29
Getting Started
P
reparation
B
asic Operation
Settings
Troubleshootin
g
O
thers
ENGLISH
Install1 > Input info.
a Input info.
Sets whether to display the input when switching input.
5 sec Displays for 5 seconds.
Off Do not display.
Install1 > Flip H
b Flip H
Select this when the image is projected from the back of the screen or when the projector is hung from the ceiling.
Off Do not flip image to the left or right.
On Flips image to the left or right.
Install1 > Flip V
c Flip V
Select this when the projector is hung from the ceiling.
Off Do not flip image up or down.
On Flips image up or down.
Install1 > Fan Speed
d Fan Speed
Select this when using the projector in a location of low atmospheric pressure (higher than 900 meters above sea level).
Normal Do not activate.
High Activate.
Install2 > Back Color
e Back Color
Configures the screen colour displayed when there is no input signal.
Blue Sets screen colour to “Blue”.
Black Sets screen colour to “Black”.
Install2 > No Signal Off
f No Signal Off
Sets the lapse time before automatically switching to the standby mode when there is no input signal.
15 Switch to standby mode after 15 minutes.
30 Switch to standby mode after 30 minutes.
60 Switch to standby mode after 60 minutes.
Off Do not switch to standby mode.
KRF-9000FDE_EN.book Page 29 Tuesday, February 19, 2008 9:16 AM