Pioneer AVIC-F840BT - Manual (Page 152)

Changing the unit between km and miles
This setting controls the unit of distance and
speed displayed on your navigation system.
1 Display the
“System Settings” screen.
= For details, refer to Displaying the screen for
system settings on page 149.
2 Touch [Regional Settings].
The
“Regional Settings” screen appears.
3 Touch [km / mile].
A message confirming whether to change the
setting appears.
4 Touch [Yes].
Each time you touch the key changes the set-
ting.
! km (default):
Shows distance in kilometres.
! mile:
Shows distance in miles.
! Mile&Yard:
Shows distance in miles and yards.
# If you touch [No], the setting is cancelled.
Changing the virtual speed of the vehicle
When calculating the expected time of arrival
and the travel time to the destination, set the
average speed for the motorway or ordinary
roads using [
+] and [
–].
1 Display the
“System Settings” screen.
= For details, refer to Displaying the screen for
system settings on page 149.
2 Touch [Regional Settings].
The
“Regional Settings” screen appears.
3 Touch [Average Speed].
The
“Average Speed Settings” screen ap-
pears.
4 Touch [+] or [ –] to set the speed.
p The estimated time of arrival may not be
taken into account other parameters than
this speed value.
5 Touch [OK].
The settings are complete.
Setting the Volume for
Guidance and Phone
The sound volume for the navigation can be
set. You can separately set the volume of the
route guidance and the beep sound.
1 Display the
“System Settings” screen.
= For details, refer to Displaying the screen for
system settings on page 149.
2 Touch [Volume].
The
“Volume Settings” screen appears.
3 Touch [+] or [
–] to set their volume.
On this screen, you can operate the following
items.
! Guidance
This setting controls the guidance volume
of navigation.
p When set to , guidance is output.
When set to , no guidance is output.
Engb
152
Chapter
27 Customising preferences