Pioneer ANH-P10MP - Manual (Page 10)

Connecting the Units
En 9
<CRD3863-A> 10
1*
2*
4*
3*
5*
Note
Depending on the kind of vehicle, the function of
3* and 5* may be different. In this case, be sure
to connect 2* to 5* and 4* to 3*.
Note
When a subwoofer is connected to this unit
instead of a rear speaker, change the rear
output setting in the Initial Setting. (Refer
to the Operation Manual.)
The subwoofer output of this unit is
monaural.
ISO connector
Note
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
C a p ( 1 * )
When not using this terminal,
do not remove the cap.
Fuse holder
Yellow (3*)
Back-up (or accessory)
Red (5*)
Accessory (or back-up)
Black (earth)
To vehicle (metal) body.
Orange/white
To lighting switch terminal.
Aerial jack
This Product
F
Speaker leads
White
White/black
Gray
Gray/black
: Front left +
: Front left ≠
: Front right +
: Front right ≠ Green
Green/black
Violet
Violet/black : Rear left + or Subwoofer +
: Rear left ≠ or Subwoofer ≠
: Rear right + or Subwoofer +
: Rear right ≠ or Subwoofer ≠
Fuse resistor
Fuse resistor
Connect leads of the same
colour to each other.
T
t
t
Yellow (2*)
To terminal always supplied with power
regardless of ignition switch position.
Red (4*)
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
Power cable connection
CRD3863A_inst_002-029_UK 4/9/04 2:05 PM Page 10