Basic setup 04 – Pioneer VSX-820-K User Manual
Page 30
Basic Setup
04
30
En
3
Press
on the remote control,
then press the SETUP button.
An on-screen display (OSD) appears on your
TV. Use
/// and ENTER on the remote
control to navigate through the screens and
select menu items. Press
RETURN to exit the
current menu.
• Press
SETUP at any time to exit the System
Setup menu.
1
4
Select ‘Auto MCACC’ from the System
Setup menu then press ENTER.
2
Try to be as quiet as possible after pressing
ENTER. The system outputs a series of test
tones to establish the ambient noise level.
5
Follow the instructions on-screen.
• Make sure the microphone is connected.
• Make sure the subwoofer is on and the
volume is turned up.
• See below for notes regarding background
noise and other possible interference.
6
Wait for the test tones to finish.
A progress report is displayed on-screen while
the receiver outputs test tones to determine the
speakers present in your setup. Try to be as
quiet as possible while it’s doing this.
• For correct speaker settings, do not adjust
the volume during the test tones.
7
Confirm the speaker configuration.
The configuration shown on-screen should
reflect the actual speakers you have.
• With error messages (such as
Too much
ambient noise) select RETRY after
checking for ambient noise (see Other
problems when using the Auto MCACC
Setup on page 31).
If the speaker configuration displayed isn’t
correct, use
/ to select the speaker and
/ to change the setting. When you’re
finished, go to the next step.
If you see an error message (
ERR) in the right
side column, there may be a problem with the
speaker connection. If selecting
RETRY
doesn’t fix the problem, turn off the power and
check the speaker connections.
8
Make sure ‘OK’ is selected, then press
ENTER.
If the screen in step 7 is left untouched for 10
seconds and the
ENTER button is not pressed
in step 8, the Auto MCACC setup will start
automatically as shown below.
Note
1 The screensaver automatically starts after three minutes of inactivity. If you cancel the Auto MCACC Setup at any time, the
receiver automatically exits and no settings will be made.
2
MIC IN blinks when the microphone is not connected to MCACC SETUP MIC.
RECEIVER
System Setup
1.Auto MCACC
2.Manual SP Setup
3.Input Assign
4.Pre Out Setting
Return
1.Auto MCACC
Now Analyzing
Environment Check
Ambient Noise
Speaker YES/NO
Return
1.Auto MCACC
Check!
OK
Return
10:Next
Front
Center
Surr
Surr. Back
Subwoofer
[ YES ]
[ YES ]
[ YES ]
[YESx2]
[ YES ]
VSX-820_SYXCN_En.book 30 ページ ２０１０年４月１２日 月曜日 午後６時５２分